Thankfully, most of this piece is going to end up frosted (in this case roughed up with fine grit sand paper) since the bubbles in the glue job look annoyingly ugly. The interior will be lit with RGB LEDs and controlled by some manner of Atmel chip.
I continue to attempt to create a block lifter that's properly aligned. This is my first attempt at 3D printed parts, my thanks to fellow EnjiGo member Duane. Much to my dismay I set the tolerances too tightly and the parts required a lot of filing and boring before I could install the hardware (which led to a misaligned linear bearing).
Last but not least, behold a laser cut glue-form for making bokken (wooden practice long sword). I recently started practicing Iaido (which is awesome) and have become interested in creating my own special brand of bokken.
