Monday, February 9, 2015

Jetson TK1 Dev Board Enclosure

Designed and laser cut an enclosure for the Jetson TK1 development board.  This design uses:
  • 1/8" acrylic plastic
  • 1/16" acrylic plastic 
  • 4 x(3mm x 60mm bolts and nuts)
  • 1/4" diameter (1/8" bore) acrylic tubing  

first three layers

two upper layers

1/4" outer diameter, 1/8" inner diameter
acrylic tubes
finished with 3mm x 60mm screws

 Alternate Orientation



  1. Replies
    1. I'd consider it. How many are you looking to buy?

      Note: I'd probably modify the enclosure design so the GPIOs are easily accessible

    2. I added you on Google+. Send me a message and we can take it from there.

  2. Hi Ian,
    I was wondering if I can buy this enclosure from you? If yes, how much and how long I can get it (I am in US). Thanks!

  3. Ben,
    Sorry to say, I'm not taking orders for the TK 1 case.